Skip Navigation Website Accessibility
 


Pedaltrain Nightlight Distortion Pedal

available at
available at

Please call or email to verify store inventory!

Pedaltrain Nightlight Distortion Pedal

“Nightlight” is an asymmetrical, full-bodied overdrive/distortion. The structure of the gain is detailed and complex. The gain will not collapse on itself/compress at high gain settings. This pedal is very dynamic and touch sensitive.

The controls are simple, just three knobs. Start with each control at 12:00 (high noon), and then experiment. We worked hard to make sure the 12:00 setting was a good starting place out of the box.

Level: Level controls the volume of the output.
Tone: Tone controls the darkness/brightness of the tone.
Drive: Drive controls the amount of overdrive/distortion.
Notice the tone knob sweep is musical and usable through the entire range. As you back off the guitar’s volume pot, the pedal cleans up. At higher gain settings the sound does not collapse on itself. Descriptions are subjective, so listen to the audio clips to see if it is right for you.

Made in the USA.
Designed, built and tested in Nashville, Tennessee.
True Bypass Switching. The devices use standard mechanical true-bypass switching. Audio will passthrough if the switch is turned off, and/or if there is no power to the pedal.
Switchcraft jacks
9V only. External power supply required. Power supply not included. There is no battery clip inside.
9-Volt DC power supply with a 2.1mm center-negative barrel connector.
Current Draw: Less than 10 mA
(9v) DC power only. Do not run at higher voltages.
Length x Width x Height (incl. sockets, knobs, etc.): 9.2” x 2.62” x 2.23” (125 x 66.5 x 56.6 mm)

Follow us on the socials

© 2024 KENNELLY KEYS

Newsletter Signup