Goodwood Audio Audition Pedalboard Demo/FX Loop Pedal - Used

Type: Used
Condition: Excellent

Since rewiring your pedal board is not something you want to be doing every time you want to try a new pedal, Audition allows you to patch in a new pedal without having to rewire your entire board. Also use Audition to integrate an amps FX loop without having to re-patch your board.

Signal Chain For Auditioning A Pedal
Audition can be placed anywhere in your signal chain. The first thing you need to decide is which types of pedals you will audition the most. If you are going to audition a lot of overdrive pedals, put Audition closer to the beginning of your signal chain. If you are going to audition modulation, delays and reverbs, put Audition closer to the end of your signal chain. If you are unsure, put Audition after your last overdrive and before your modulation effects.

Signal Chain For Using An Amps FX Loop
If you are going to be using an amp's FX loop, place Audition after your last overdrive/dry effect and route signal as follows:

1. Last dry effect to Audition "In" jack
2. Audition "Send" to amp input
3. FX Send from amp to Audition "Return"
4. Audition "Out" to first modulation / wet effect
5. Last wet effect sends to amp FX Return

If you don't want to use the FX loop, simply unplug the send and return jacks and plug the last pedal on your board to the amp input.

In this configuration you can still audition pedals as normal.

Push Button
The push button is on Audition for musicians running Audition underneath their angled pedal board. Since a lot of angled pedal boards come with side panel jacks, you can now patch Audition into the side panel jacks and turn Audition ON to try a new pedal, or turn Audition OFF to bypass the side panel jacks and pass signal un-interrupted.