Dirty Haggard Audio DH-2 Death Fuzz Distortion Pedal
The Death Fuzz, inspired by the cult favorite FY2/Companion Fuzz by Shin-ei, is THE FUZZ WITHOUT THE BUZZ
Designed by an audio engineer and built out of time-tested components to last for decades. The Death Fuzz reproduces the coveted fuzz of the FY2 but corrects its equally famous flaws. The Death Fuzz gives you a virtually silent noise floor, mid control, corrected output signal, corrected gain, radio-frequency rejection, and elimination of power-supply noise. This is a pedal designed by a Portland musician with a day job as an audio analysis technician.
Our flagship pedal gives you the fuzz without the buzz.
- Added Noise Gate
The Companion Fuzz (as is the case with most fuzz pedals) was known to have a loud noise-floor/lots of hiss. The Death fuzz has a toggle switch to kill the hiss and noise without affecting sound quality. The result is silence when not playing or during breaks within your riffs. Or you can toggle the gate off for the classic vintage feel.
- Filter Control
The original Companion Fuzz pedal had a hard-wired band-reject filter, resulting in a constant midrange scoop. The Death Fuzz features a unique filter design which changes the overall character of the sound across the whole frequency spectrum, giving you much more tone control while retaining the feel of the original.
- Power Supply Filtering
Aggressive low-pass filtering of the DC power supply for maximum noise and ripple rejection. Made with high quality electrolytic and ceramic capacitors which are rated for much higher voltage applications. The result is minimal wear and tear on these capacitors over time, ensuring decades of quiet operation.
- Redesigned Gain Circuitry
The original gain structure pitted two out-of-phase transistors against each other through a variable resistor(gain pot). This added to the low-output volume problem of the pedal and produced a limited range of function. The redesigned gain structure keeps out-of-phase signals from clashing with one another, giving you a much wider range of function, from a 'voltage starved' sound when used with the gate, to full brutality with or without the gate.
- Added Output Amplifier
The added output amplifier corrects the originals low output signal, with the added benefit of having a much more agreeable 10k ohm output impedance so it will play nicely with your other effects pedals.
- Radio Frequency Rejection
2-stage RFI/EMI input filtering prevents radio frequencies from entering the circuit so you don't have any annoying radio pickup coming out of your amp.
- Quality Circuit Boards
Durable printed circuit boards built to last. Buy right or buy twice.